Linux Migration Backup (If Current Release Is 1.X) - Avaya G700 Installation Manual
Media gateway and media server
Hide thumbs
Also See for G700:
- Installing and upgrading (808 pages) ,
- Installing manual (768 pages) ,
- Installation and upgrades (734 pages)
Table of Contents
Advertisement
Upgrading an Existing S8300A to R2.2
6. Type patch_show and press Enter to list Communication Manager files to verify the new
software file was installed.
7. Type sudo patch_apply patch and press Enter.
where patch is the release or issue number of the update file. (For example,
03.0.526.5-1003. Do not use the *.tar.gz extension at the end of the file name).
The media server goes through a software reset system 4. You must wait until the
restart/reset has completed before entering additional commands. The reset should take
1–2 minutes (or longer if messaging is enabled).
8. Type patch_show again and press Enter to list Communication Manager files to verify the
new software file was applied.
9. Before proceeding, type statapp -c to view the status of the processes.
Make sure everything except dupmgr shows UP. Communication Manger should show
65/65 UP or, if IA770 is installed, 67/67 UP. To stop the continual refresh of the
statapp command, type Ctrl-C.
Note:
The number of processes (65/65) may vary depending on the configuration. For a
Note:
normal state, the second number should not be greater than the first number. For
example, the numbers 64/65 UP would indicate that a process did not come up
and should be investigated before proceeding.
10. Close the telnet session.
Linux migration backup
(if current release is 1.x)
!
Important:
Skip to
Important:
current software release is 2.x. If you are upgrading from a 2.x release, the Linux
Migration Backup may not work. After the upgrade, you will restore data from the
system backup you did earlier.
In this section, you will use the Linux Migration Backup procedure on the Maintenance Web
Interface to save the system files and translations. After the upgrade, you will use the Linux
Migration Restore feature to restore these files.
To perform the Linux migration backup
1. Launch the Maintenance Web Interface. Under Server Configuration click Linux Migration
(Backup/Restore).
The Linux Migration - Backup screen displays.
264 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Replacing the S8300A with the S8300B Media Server
on page 267 if the
Advertisement
Table of Contents
