Configure the G700
Tip:
The Avaya Gateway Installation Wizard (GIW) performs tasks automatically in
Tip:
the sections:
Assigning the IP addresses of the G700 media gateway components
Checking for IP connections
Setting the LSP Transition Points
However, the GIW does not configure an X330 Expansion module. This task you
must still perform manually, as described in:
Configuring an X330 Expansion Module (If Necessary)
For a new installation of a G700 Media Gateway, you must complete the following configuration
tasks:
1. Assign IP addresses to the G700 processors
2. Assign IP routes for the gateway
3. Set up the controller list
Assigning the IP addresses of the G700 media gateway
components
Tip:
The Avaya Gateway Installation Wizard (GIW) performs this task automatically.
Tip:
This section describes how to assign the IP addresses and IP routes to the G700 Media
Gateway and its components. The IP addresses should be available to you on the IP
Addressing Planning Form. The command arguments you will be supplying include:
VLAN — Virtual Local Area Network: a defined network segment that allows users on that
segment to have priority services in sharing information with each other.
If the network is not using VLANs, the VLAN should be 1. Otherwise, use the VLAN
numbers indicated in your planning forms. The G700 Media Gateway should be assigned
the same VLAN as the VLAN to which the Ethernet ports are connected. The P330 stack
processor might or might not be assigned to the customer's network management VLAN.
Configure the G700
Issue 7 January 2005
201