Avaya G700 Installation Manual page 208

Installing a New G700 without an S8300
To set the MGP controller list
1. At the MG-???-n(configure)# prompt, type the following commands to designate the
primary, secondary, and LSP controllers for this G700:
a.clear mgc list
b. set mgc list <ip_address> [,<ip_address> [,<ip_address>
[,<ip_address>]]]
where, the first <ip_address> is the IP address of the primary controller for this G700.
If the primary controller is an S8700, this is the IP address of a C-LAN board that is
connected to a pair of duplicated S8700/S8710s. If the primary controller is an S8300,
this is the IP address of the S8300.
The next three <ip_address> parameters are optional IP addresses of up to three
alternate controllers. Each of the three optional controllers can be an S8700/S8710
duplicated pair or an S8300 configured as an LSP, depending on the G700's primary
controller.
!
CAUTION:
If you need to change the mgc list, you must run clear mgc list before
CAUTION:
running set mgc list again.
Table 11
controller:
Table 11: Possible optional controllers for various primary controllers
If primary
controller is
S8300
S8500 or
S8700 or
S8710
Note:
For an S8500 or S8700/S8710 primary controller, the last three IP addresses in
Note:
the list can be either the addresses of C-LANS (which are connected to the same
S8500 or pair of S8700/S8710s that act as primary controllers) or addresses of
LSPs. If you enter a combination of both, you must list C-LANs first and the LSPs
last, after the C-LANs.
208 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
describes the possible optional controllers for an S8300 and S8700/S8710 primary
Then, controller IP addresses can be
First: IP address of the S8300 primary controller.
Next three: one, two, or three IP addresses of S8300s
configured as LSPs.
First: IP address of the C-LAN for the S8500 or S8700/
S8710 primary controller.
Next three: one, two, or three IP addresses of alternate
C-LANs and/or LSPs.