Avaya G700 Installation Manual page 167

To install media module firmware
1. Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on
the G700 motherboard).
This VoIP module does not occupy a physical position like other media modules.
2. At the P330-1(configure)# prompt, type session mgp.
3. At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
4. Type copy tftp mm-image v<slot #> <filename mm>
<tftp_server_ip_address>
where
<slot #> is the slot of the specific media module,
<filename mm> the full-path name of the media module firmware file in a format such as
mm712v58.fdl, and
<tftp_server_ip_address> is the ip address of the S8300.
Two or three minutes will be required for most upgrades. The VoIP media module upgrade
takes approximately 5 minutes. Screen messages indicate when the transfer is complete.
5. After you have upgraded all the media modules, verify that the new versions are present.
At the MG-???-1(configure)# prompt, type show mg list_config
The list of software appears.
Show MG list_config
SLOT TYPE CODE
---- ------ -----
V0 G700 DAF1
V1 ICC S8300
V2 DCP MM712
V3 ANA MM711
V4 DS1 MM710
6. In the TYPE column, find the particular media module (v1 through v4), then check the
matching field in the FW VINTAGE column to see if it matches the planning documentation.
Note:
Slot V1 can contain either a media module or the S8300, which will show as
Note:
TYPE ICC.
7. Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP
firmware identified in the planning documentation.
SUFFIX HW VINTAGE
------ ----------
A 00
A 00
A 2
A 3
A 1
Install New Firmware on the G700
FW VINTAGE VOIP FW
---------- -------
21.25.0(A) 26
5 N/A
5 N/A
16 N/A
8 N/A
Issue 7 January 2005 167