Trace Descriptor Labels - Teledyne LabMaster 10 Zi Series Getting Started Manual

LabMaster 10 Zi Oscilloscopes
where the new level ends up when triggering resumes. Push the LEVEL knob
to reset the level to 50%.
S D
IGNAL ISPLAY
On the Signal Display Grid, the Pop-up menu provides
assistance while using the oscilloscope.
Clicking on a waveform opens a pop-up menu. From this
pop-up menu, you can perform the following functions:

Open the Setup dialog for the trace

Turn the trace descriptor label off

Open the Math dialog for the trace

Open the Measure dialog for the trace

Annotate the selected trace

Trace Descriptor Labels

Shown just beneath the grid display, these boxes provide a summary of your
channel, timebase, and trigger settings.
When a trace is selected its corresponding descriptor label is shown
highlighted.
The C1 Trace Descriptor Label is selected; C2 is not.
Make vertical or horizontal channel adjustments by touching the respective
label. The setup dialog for the function is shown beneath.
Channel trace labels show the vertical settings for the trace and cursor
information (if cursors are in use). The title bar of the label includes
indicators for (SinX)/X interpolation, waveform inversion (INV), deskew
46
Zero Volts Level - This indicator is located at the left
edge of the grid. Change the zero volts level by
turning the vertical OFFSET knob. Push the knob to
reset the indicator to the middle of the grid.
G P -U M
RID OP P ENU
922561-00 Rev A