Table of Contents
Advertisement
Procedure
•
Connect power cable.
•
On the RTM IP card, connect the LAN cable to LAN 2.
A RealPresence Collaboration Server (RMX) 2000 always requires that an RTM IP card be installed
in the bottom slot on the rear of the RealPresence Collaboration Server (RMX) 2000.
•
Install a 4 LAN ports RTM LAN card and connect the LAN cable to LAN 2.
In MPMRx Card mode, an MPMRx card on the front of the RMX must always be seated or
connected opposite to either a 4 LAN ports RTM LAN card or RTM ISDN card on the rear of the
chassis. The 2 LAN ports RTM LAN card is not supported with MPMRx card.
An RTM LAN card is always required with Multiple Networks and LAN Redundancy configurations.
With Multiple Networks and LAN Redundancy configurations, connect the LAN cable to LAN 1.
•
If either RTM ISDN card is selected to install with MPMRx card, perform following steps:
a) Connect the RJ-45 terminated E1/T1 cables to PRI ports.
b) When the one LAN port RTM ISDN card is installed, connect the LAN cable to LAN 1; In
MPMRx card mode and when the four LAN ports RTM ISDN card is installed, connect the
LAN cable to LAN1 and LAN 2.
RMX 2000 rear panel view with cables
Installing the RealPresence Collaboration Server
(RMX) 4000
The Polycom RealPresence Collaboration Server 1800/2000/4000 Appliance Edition can be installed in a
rack.
Install RTM ISDN Card on the RealPresence Collaboration Server
(RMX) 2000/4000
If the ISDN option was purchased with your RealPresence Collaboration Server, the ISDN card is shipped
separately and must be manually installed into the rear of the system. It is recommended to install the
ISDN card before the system is placed in a rack.
An RMX Software License is included with the ISDN card and must be registered as part of the Product.
Polycom, Inc.
Appliance Edition Installation
22
Advertisement
Table of Contents
