RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Getting Started Guide
An RealPresence Collaboration Server (RMX) 2000 always requires that an RTM IP card be
installed at the bottom slot on the rear of the RealPresence Collaboration Server (RMX) 2000. RTM
LAN and RTM ISDN cards are optional configurations that require a media card be connected from
the front of the RealPresence Collaboration Server (RMX) 2000. For more information, see
<Italic>RealPresence Collaboration Server (RMX) 2000 Hardware Guide,
LAN Card - with 4 LAN Ports
Installing the RealPresence Collaboration Server (RMX) 4000
The following procedures have to be performed to install the RealPresence Collaboration Server
(RMX) 4000 at your site:
● Optional. Installing the RTM ISDN card on the Collaboration Server
● Mounting the Collaboration Server in a rack
● Connecting the Collaboration Server to the power source
● Connecting the network (LAN and ISDN) cables to the Collaboration Server
Installing the RTM ISDN Card on the RealPresence Collaboration Server
(RMX) 4000
If the ISDN option was purchased with your Collaboration Server, the ISDN card is shipped separately and
must be manually installed into the rear of the RealPresence Collaboration Server (RMX) 2000. It is
recommended to install the ISDN card before the RealPresence Collaboration Server (RMX) 2000 is placed
in a rack.
Removing the RTM LAN Card or the blank cover from the rear of the RealPresence
Collaboration Server (RMX) 4000
1 Ensure that the power switch on the Collaboration Server is turned OFF (O).
2 Remove the RTM LAN or blank cover by unscrewing the captive screws that fasten the card or the
cover to the Collaboration Server. When removing a card, use the metal ejector levers to pull the
RTM LAN card out of its slot from the backplane.
3 Slide out the RTM LAN or RTM ISDN card.
Installing the RTM ISDN 4000 Card
1 On the RTM ISDN card move the ejector levers to their fully open position.
Polycom®, Inc.
.
RTM ISDN
and
RTM
46
Need help?
Do you have a question about the 1500 and is the answer not in the manual?
Questions and answers