Installing The Realpresence Collaboration Server (Rmx) 4000 - Polycom RealPresence 1800 Getting Started Manual

P R P C
OLYCOM EAL RESENCE OLLABORATION
Installing the RealPresence Collaboration
Server (RMX) 4000
Install RTM ISDN Card on the RealPresence Collaboration Server (RMX)
2000/4000
Remove an RTM LAN or Existing ISDN Card
P R P C
OLYCOM EAL RESENCE OLLABORATION
S .8.6
ERVER V
The Polycom RealPresence Collaboration Server 1800/2000/4000 Appliance
Edition can be installed in a rack.
If the ISDN option was purchased with your RealPresence Collaboration Server,
the ISDN card is shipped separately and must be manually installed into the rear
of the system. It is recommended to install the ISDN card before the system is
placed in a rack.
An RMX Software License is included with the ISDN card and must be regis-
tered as part of the Product. For more information, see Registering Product.
If your RTM LAN or ISDN card is broken, you can remove and replace it with
a new one.
T
ASK
1. To remove an RTM LAN or existing ISDN card:
2. Ensure that the power switch on the Collaboration Server is turned OFF
(O).
3. Remove the RTM LAN or blank cover by unscrewing the captive screws
that fasten the card or the cover to the Collaboration Server.
A I
DDITIONAL NFORMATION
pull the RTM LAN card out of its slot from the backplane.
S G S
ERVER ETTING TARTED
I R P
NSTALLING THE EAL RESENCE
: When removing a card, use the metal ejector levers to
G
UIDE
A E I
PPLIANCE DITION NSTALLATION
C S (RMX) 4000
OLLABORATION ERVER
33