Installing Power Supplies In The Brocade Mlxe-8 Router - Brocade Communications Systems MLX Series Installation Manual

5. Rotate the ejectors until they are flush with the module faceplate. This action will fully seat the
6. Tighten the screws at each end of the module faceplate by pushing them in and turning them
7.
FIGURE 54
8. Rotate the ejectors flush with the module faceplate to fully seat the module in the backplane.
9. Tighten the two screws on each side of the module faceplate by pushing them in and turning

Installing power supplies in the Brocade MLXe-8 router

You need a small Phillips or flat-blade screwdriver to install additional power supplies.
Follow these steps to install a power supply in the Brocade MLXe-8 router.
1. Remove the power supply slot blank.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02
NOTE
When inserting the module into the router, be sure that the faceplate does not overlap the
faceplate of an adjacent module.
module in the backplane.
clockwise. Complete the tightening process using the flat-blade screwdriver.
Enter the write memory command to ensure that the slot will be correctly configured for the
new module after a reboot.
Brocade(config)# write memory
Write startup-config done.
Installing a module in a Brocade MLXe-8 router
Modules have a snug fit for maximum EMI protection.
them clockwise. Complete the tightening process using a flat-blade screwdriver.
Installing a Brocade MLXe-8 router
2
85