Removing Mac Address Entries - Brocade Communications Systems MLX Series Installation Manual

7

Removing MAC address entries

NOTE
The total CPU usage may not add up to 100 percent. The total may not include resources used by
the management processes.
A problem could exist If the CPU usage is distributed unevenly to one task, other than the idle task,
for a prolonged period. If this situation occurs, contact Brocade Technical Support for assistance.
Removing MAC address entries
You can remove the following learned MAC address entries from the system MAC address table:
•
•
•
•
•
For example, to remove entries for the MAC address 000d.cb80.00d in all VLANs, enter the
following command at the Privileged EXEC level of the CLI.
Brocade# clear mac-address 000d.cb80.00d0
Syntax: clear mac-address <mac-address> [ethernet <slot-num>/<port-num>] | [module
•
•
•
•
•
348
All MAC address entries
All MAC address entries for a specified interface module
All MAC address entries for a specified Ethernet port
All MAC address entries for a specified VLAN
A specified MAC address entry in all VLANs
<slot-num>] | vlan <number>
If you enter the clear mac-address command without any parameters, the software removes all
MAC entries.
Use the <mac-address> parameter to remove a specified MAC address from all VLANs. Specify
the MAC address in the following format: HHHH.HHHH.HHHH.
Use the ethernet <slot-num>/<port-num> parameter to remove all MAC addresses for a
specified Ethernet port. For the <slot> parameter, enter the number of the device slot in which
the Ethernet interface module is installed. For the <port> parameter, enter the Ethernet port
for which to remove all MAC addresses.
Use the module <slot-num> parameter to remove all MAC addresses for an interface module in
a specified device slot.
Use the vlan <number> parameter to remove all MAC addresses for a specified VLAN.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02