Brocade Communications Systems MLX Series Installation Manual page 312

4
Installing a Brocade NetIron XMR 32000 router
FIGURE 208
1
1 Lug screws
3. Crimp the correct AWG wire into the power lugs:
CAUTION
For the NEBS-compliant installation of a Brocade NetIron XMR 4000, 8000, and 16000 routers
with AC and DC systems, use a ground wire of at least 6 American Wire Gauge (AWG). The ground
wire should have an agency-approved crimped connector (provided with the router) attached to
one end, with the other end attached to building ground. The connector must be crimped with the
proper tool, allowing it to be connected to both ground screws on the enclosure. Before crimping
the ground wire into the provided ground lug, insure the bare copper wire has been cleaned and
antioxidant is applied to the bare wire.
294
Removing the power lugs (2400W power supply and 3000W power supply displayed)
2 Power lug (2)
For 2400 W power supply, crimp #4 AWG
For 3000 W power supply, crimp #2 AWG.
Refer to Figure 209.
2
Brocade MLX Series and NetIron XMR Hardware Installation Guide
1
2
53-1002373-02