Connecting Ac Power - Brocade Communications Systems MLX Series Installation Manual

Follow these steps to install a power supply in the router.
1. Remove the power supply slot blank and store if for future use.
2. Remove the power supply from the packaging.
3. Insert the power supply into the slot and slide it along the guides on each side of the slot. Refer
NOTE
Empty power supply slots must be covered with slot blanks.
Do not overtighten screws when installing power supplies.
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted in the guides. Never insert the power supply upside down.
FIGURE 113
4. Push the power supply front panel into the router until it engages the backplane connector.
5. Rotate the ejector levers towards the front of the power supply to secure it in place.
6. Tighten the two screws on the power supply front panel by pushing them in and turning them
For information about connecting power to the router, refer to
or "Connecting DC power"

Connecting AC power

AC power is supplied through a power cord connected to the AC power supply installed in the router.
NOTE
For the NEBS-compliant installation, AC power connections must use a surge protection device
(SPD) to protect the AC power supplies from damage due to excessive power line surges.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02
to Figure 113.
Installing a power supply in a Brocade MLX-4 router
clockwise. Finish tightening the screws using the flat-blade screwdriver.
on page 162.
Installing a Brocade MLX-4 router
"Connecting AC power"
3
on page 161
161