Brocade Communications Systems MLX Series Installation Manual page 45

TABLE 6
Router type
MLXe-16
Brocade NetIron
XMR 1600
MLXe-32
Brocade NetIron
XMR 3200
8x10GE-X interface modules
The 8x10GE-X interface modules provide 8 ports of 10 Gigabit Ethernet with support for 1M IPv4
routes in hardware.
NOTE
Gen-2 8x10GE-X modules require high speed switch fabric modules to operate. You can replace
switch fabric modules with high-speed switch fabric modules while the system is powered on and
running. For more information about high-speed switch fabric modules, refer to
fabric modules"
Figure 16
FIGURE 16
8x10GE-X modules support SFP+ optics only; they do not support SFP or CFP optics. For a list of
supported SFP+ optics, refer to the latest version of the Brocade Optics Family Data Sheet,
available online in the following location:
http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_DS.p
df
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02
Power supply requirements for 100xGbE modules (Continued)
Number of 100xGbE
modules installed
six
seven to eight
eight (1x100GE)
twelve
thirteen to sixteen
sixteen (1x100GE)
on page 50.
shows the faceplate of the 8x10GE-X module.
8x10GE-X module faceplate
1
2
Power supply requirements (minimum required-redundancy requirements)
four 1200W PSU
for 4+4 redundancy, install eight 1200W PSU
for 3+3 redundancy, install four 1800W PSU
a minimum of five 1200W PSU
for 4+4 redundancy, install eight 1800W PSU
for 5+3 redundancy, install eight 1200W PSU
four 1200W PSU
for 4+4 redundancy, install eight 1200W PSU
four 2400W PSU
for 4+4 redundancy, install eight 2400W PSU
five 2400W PSU
for 5+3 redundancy, install eight 2400W PSU
four 3000W PSU
for 4x4 redundancy, instal eight 3000W PSU
four 2400W PSU
for 4+4 redundancy, install eight 2400W PSU
7
8
1
Router modules
"High-speed switch
27