Installing A Brocade Mlx-4 Router In A Rack - Brocade Communications Systems MLX Series Installation Manual

3
Installing a Brocade MLX-4 router
FIGURE 109
1

Installing a Brocade MLX-4 router in a rack

Because of the weight of a fully loaded Brocade MLX-4 router, Brocade recommends mounting it in
a rack before installing the modules and AC power supplies.
You can install up to eight Brocade MLX-4 routers in a standard 19-inch (EIA310-D) rack. You can
install the routers in either a front-mount configuration (using the factory-installed mounting
brackets) or a mid-mount configuration. For a mid-mount configuration, simply remove the
factory-installed mounting brackets from the front edges of the device and re-attach them to the
center sides of the device using the pre-drilled holes.
NOTE
You will need to provide four standard #12-24 pan-head screws per router and a #2 Phillips
screwdriver to secure each router in the rack.
Follow these steps to mount a Brocade MLX-4 router in a rack.
1. Determine the position of each router in the rack according to the weight of the router. For
2. Using the keyhole slots in the router mounting brackets as a guide, align one screw per rack
156
Removing the shipping screws
1
3
Front 2 Rear
example, mount the router with the fewest modules near the top of the rack, the router with
more modules near the middle of the rack, and a fully populated router near the bottom of the
rack.
post, as shown in Figure
in the mounting bracket. On the other side of the rack, the screw should align with the bottom
hole of the mounting bracket. When tightening these screws, leave approximately 1/4 inch of
clearance between the back of the screw head and the rack post.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide53-1002373-02
3 Shipping screws
110. On one side of the rack, the screw should align with the top hole
2