Brocade Communications Systems MLX Series Installation Manual page 269

Follow these steps to connect DC power source:
NOTE
Due to multiple power supply vendors, the layout of the LEDs on your DC power supply may differ
from what is shown in
1. Use a #1 Phillips screwdriver to remove the two screws that hold the transparent cover over
FIGURE 174
1 Screws holding transparent cover
2. Use a #2 Phillips screwdriver to remove the power lugs, as shown in
3. Crimp #8 AWG power supply wire into the power lugs and reconnect the lugs to the power
CAUTION
For the NEBS-compliant installation of a Brocade NetIron XMR 4000, 8000, and 16000 routers
with AC and DC systems, use a ground wire of at least 6 American Wire Gauge (AWG). The ground
wire should have an agency-approved crimped connector (provided with the device) attached to
one end, with the other end attached to building ground. The connector must be crimped with the
proper tool, allowing it to be connected to both ground screws on the enclosure. Before crimping
the ground wire into the provided ground lug, insure the bare copper wire has been cleaned and
antioxidant is applied to the bare wire.
CAUTION
To ensure adequate bonding when attaching the ground lug, a minimum of 20 PSI of torque is
required to be applied to the mounting hardware used to attach the ground lug.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02
Figure 174, but their function is the same.
the power supply lugs, as shown in
The Brocade NetIron XMR 4000 DC power supply
2
1 1
supply unit.
Installing a Brocade NetIron XMR 4000 router
Figure 174. Remove the transparent cover.
2 Screws holding power lugs
4
Figure 174.
251