Brocade Communications Systems MLX Series Installation Manual page 376

8
Replacing a power supply
FIGURE 230
1
2
3
4
5
4. Insert the new power supply into the empty power supply slot, using the guides provided on
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted in the guides. Never insert the power supply upside down.
5. After you insert the power supply, push gently on the power supply faceplate until the power
6. Pull up on the handle on the power supply faceplate to lock the power supply in place.
358
Removing and replacing a power supply in a 32-slot device.
Power supply indicators
AC OK
DC OK
ALM
Latch handle open
either side of the slot.
supply is fully seated.
2
AC OK
3
DC OK
ALM
4
1
5
6
7
8
9
6 Latch handle locked
7 Power supply blank cover
8 Pull down on plunger to remove
9 Power supply
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02