High-Speed Switch Fabric Modules; Power Supplies - Brocade Communications Systems MLX Series Installation Manual

1
Router modules
TABLE 24
LED
Active

High-speed switch fabric modules

Gen-2 high-speed fabric (HSF) modules support wire-speed forwarding for all packet sizes,
including jumbo frames.
NOTE
Gen-1 switch fabric modules and Gen-2 HSF module are not compatible and will not operate
together in the same device.
HSF modules are supported on Brocade MLX Series and Brocade NetIron XMR routers, and are
interoperable with all existing interface modules.
HSF modules are hot-swappable, which means you can install or replace them while the system is
powered up and running.
NOTE
Hot-swapping or installing high-speed switch fabric modules one-at-a-time may affect the
performance of 2x100GbE interface modules. If you have 2x100GbE modules in your device, it is
recommended that you bring your system down and install all required high-speed switch fabric
modules before you bring the system back up.
HSF modules can operate in normal mode or turbo mode but will boot in turbo mode only if all
active interface modules are Gen-2 modules. For a list of Gen-1 and Gen-2 modules, refer to
Table

Power supplies

Brocade offers the following power supply types:
•
•
•
•
•
Brocade MLX Series and Brocade NetIron XMR routers support the following power supply options:
•
50
Switch fabric module LEDs (Continued)
Position
Below Pwr LED
3.
1200W AC or DC power supply (ships standard with 4, 8, and 16-slot devices)
1800W AC or DC power supply
2100W AC or DC power supply (no longer available)
2400W AC or DC power supply
3000W AC or DC power supply
4-slot router: Supports 1200W and 1800W AC and DC power supplies.
•
MLX and XMR devices can accommodate three 1200W power supplies. For power
redundancy you must purchase additional power supplies depending on how you populate
your router.
•
MLXe devices can accommodate four 1200W or 1800W power supplies. For power
redundancy, you must purchase additional power supplies depending on how you populate
your router.
State Meaning
On The switch fabric is active and ready to switch user packets.
Off for The switch fabric is not active and cannot switch user packets.
extended
period
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02