Brocade Communications Systems MLX Series Installation Manual page 201

1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on
2. Using the flat-blade screwdriver, loosen the four captive screws that secure each fan assembly
3. Remove the standard fan assemblies by inserting your fingers underneath each assembly and
DANGER
Be careful not to insert your fingers into the fan while removing it. The fan may still be spinning at
a high speed.
FIGURE 129
1 Power connector
4. Insert the high-speed fan assembly into the fan slot and push the assembly in until the
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02
the front of the device.
to the device.
pulling it toward you as shown in
Removing a standard fan assembly from the Brocade MLX-16-slot router
2 Fan assembly
connection plate is flush with the device. Pushing the assembly in seats the fan connector with
the device connector. Refer to
Installing a Brocade MLX-16 router
Figure 129.
3 Captive screws
Figure 130.
3
183