Brocade Communications Systems MLX Series Installation Manual page 268

4
Installing a Brocade NetIron XMR 4000 router
FIGURE 173
1 Ground point
2 Power cord
DANGER
If the installation requires a different power cord than the one supplied with the router, make
sure you use a power cord displaying the mark of the safety agency that defines the regulations
for power cords in your country. The mark is your assurance that the power cord can be used
safely with the router.
4. For information about powering on the system, refer to
Connecting DC power
You can provide DC power for the Brocade NetIron XMR 4000 router using a DC-to-DC power
supply. DC power must be supplied at 48 V and 40 A. The DC-to-DC supply provides the DC power to
the router at 12 V and 100 A.
DANGER
The procedure in this section is for qualified service personnel.
250
Connecting a power cord to the power supply in a Brocade NetIron XMR 4000 router
3 Cord retainer
page 297.
1
"Activating the power source"
Brocade MLX Series and NetIron XMR Hardware Installation Guide
3
2
on
53-1002373-02