Brocade Communications Systems MLX Series Installation Manual page 225

3. Adjust the telescoping rails to fit your rack. The rails can accommodate rack depths from 27 -
4. Attach the side rails to the front and back of the rack, using screws appropriate for your rack
FIGURE 144
5. Use the mechanical lift to position the chassis as close to the rack as possible. Slide the
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02
31 inches.
type. (You must provide these screws). Refer to
NOTE
The narrow telescoping ends of the side rails should attached at the back of the rack.
Attach the telescoping side rails to the rack.
chassis off the lift and onto the side rails and gently guide the chassis into the rack. Refer to
Figure 145.
Installing a Brocade MLX-32 router
Figure 144.
3
207