Brocade Communications Systems MLX Series Installation Manual page 47

Gen-1 10Gx2 and 10Gx4 Ethernet interface modules
Gen-1 2-port and 4-port 10 Gbps Ethernet interface modules are available in the following formats:
•
•
•
•
NOTE
When you install Gen-1 2-port or 4-port 10 Gbps Ethernet interface modules, you must upgrade the
software on all interface modules and management modules to the appropriate software release.
For more information on the appropriate software release refer to the Hardware Installation Notes
that shipped with the interface module.
Figure 17
FIGURE 17
The front panel of the 2-port module includes the following features:
•
•
The front panel of the 4-port module includes the following features:
•
•
10 Gbps Ethernet interface module LEDs
Gen-1 2-port and 4-port interface modules have LEDs that indicate the status of each port, as
described in
TABLE 9
LED
Link
Active
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02
NI-MLX-10Gx2 - 2-port interface module for MLX devices
NI-XMR-10Gx2 - 2-port interface module for XMR devices
NI-MLX-10Gx4 - 4-port interface module for MLX devices
NI-XMR-10Gx4 - 4-port interface module for XMR devices
shows Gen-1 2-port and 4-port 10 Gbps Ethernet interface module front panels.
Gen-1 2-port and 4-port 10 Gbps Ethernet module front panels
1
1
Two LEDs per port (as described in
Two 10 Gbps Ethernet XFP optics ports
Two LEDs per port (as described in
Four 10 Gbps Ethernet XFP optics ports
Table 9.
Gen-1 2-port or 4-port 10 Gbps Ethernet module LEDs
Location
Left of each
Ethernet port
Left of each
Ethernet port
2
3
2
Table 9)
Table 9)
State Meaning
On A link is established with the remote port.
Off A link is not established with the remote port.
On The port is transmitting and receiving packets.
Off The port is not transmitting or receiving packets.
Router modules
4
1
29