Brocade Communications Systems MLX Series Installation Manual page 394

8
Replacing fan assemblies
FIGURE 249
4. Remove the fan assembly handle by detaching the two screws from the inside of the fan
FIGURE 250
5. Orient the upward deflector on the fan assembly faceplate so that the exhaust will flow upward
376
Removing the louver on a legacy chassis.
The louvers will fall out of the fan assembly faceplate as you pull out the roll pins. Refer to
Figure 249.
assembly faceplate using a Phillips screwdriver. Refer to
Handle removal
and the holes in the upward deflector align with the holes where the screws secure the handle
to the fan assembly faceplate. Refer to Figure 250 in step 4.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
Figure 250.
53-1002373-02