Fujitsu F2MC-8L F202RA Hardware Manual page 192

CHAPTER 8 8/16-BIT CAPTURE TIMER/COUNTER
Table 8.4-3 Explanation of Functions of Each Bit in Timer 1 Control Register (TCR1)
Bit name
TIF1:
bit7 Compare match
detection flag bit
TFCR1:
bit6 Compare match
detection flag clear bit
T1IEN:
bit5 Interrupt request enable
bit
bit4 Not used
bit3 TCS12, TCS11, TCS10:
to Clock source selection
bit1 bits
TSTR1:
bit0
Timer start bit
Note:
When using timer 1 in the 16-bit mode, write 111
control timer 1 with TCR0.
176
• This bit is set to "1" when the counter value of timer 1 matches the value
(comparator data latch) set in the timer 1 data register (TDR1).
• An interrupt request is output when this bit and the interrupt request enable bit
(T1IEN) are "1".
Note:
In the 16-bit mode, the TIF0 bit of TCR0 is valid. The TIF1 bit is unrelated to
operation.
• This bit is used to clear the compare match detection flag bit (TIF1). When this
bit is set to "1", the compare match detection flag is cleared. The flag is not
affected even if this bit is set to "0".
• This bit is used to allow and prohibit interrupt request output to the CPU.
• An interrupt request is output when this bit and the interrupt request enable bit
(T0IEN) are "1".
• This bit is undefined at read.
• At write, this bit does not affect operation.
• These bits are used to select the count clocks to be supplied to the counter.
• Of seven internal clocks, select one.
• When 111 is written to these bits, timer 1 operates as the 16-bit mode.
B
Note:
In the 16-bit mode, the TCS02, TCS01, and TCS00 bits are valid. The TCS12,
TCS11, and TCS10 bits are used to select the 16-bit mode only.
• This bit is used to start and stop the counter.
• When this bit is set to "1", the counter is cleared and incremented according to
the selected count clock. When this bit is set to "0", the counter stops its
operation.
• In the 16-bit mode, only the TSTR0 bit can be used to start the timer. The
TSTR1 bit is unrelated to operation.
Function
to the TCS12, TCS11, and TCS10 bits and then
B