Reset - Fujitsu F2MC-8L F202RA Hardware Manual

3.5

Reset

There are four sources of reset:
• External reset
• Software reset
• Watchdog reset
• Power-on reset
Oscillation stabilization wait time is not applied in some operating modes when a reset
occurs or in some option settings.
■
Reset Sources
Table 3.5-1 Reset Sources
Reset source
External reset
Software reset
Watchdog reset
Power-on reset
● External reset
External reset occurs when "L" level is input to the external reset pin (RST). When the reset pin becomes
"H" level, the external reset is cancelled.
For external reset when power is turned on or in stop mode, the reset operation is performed after
oscillation stabilization wait time is up or the external reset is cancelled.
The external reset pin functions as the reset output pin in accordance with option settings.
● Software reset
Software reset generates a 4-instruction cycle reset by writing "0" into the software reset bit in the standby
control register (STBC: RST). Software reset does not wait until oscillation stabilization wait time has
expired.
● Watchdog reset
Watchdog reset generates a 4-instruction cycle reset when no data is written into the watchdog control
register (WDTC) within a specified time after the watchdog timer is activated. Watchdog reset does not
wait until oscillation stabilization wait time is up.
The external reset pin is "L" level.
"0" is written into the software reset bit in the standby control register (STBC:
RST).
The watchdog timer overflows.
Power is turned on.
Reset condition
CHAPTER 3 CPU
43