Fujitsu F2MC-8L F202RA Hardware Manual page 120

CHAPTER 4 I/O PORTS
● Port 6 pull-up setting register (PUL6)
The bits of the pull-up setting register correspond to the pins of port 6 in one-to-one correspondence.
When the pull-up resistor is selected by using the pull-up setting register, the pin will be at "H" level
(pull-up state) instead of Hi-Z during stop (SPL = 1). During a reset, however, the pull-up is invalid and
the pin remains at Hi-Z.
Figure 4.6-2 shows the pull-up resistor settings assigned to the values of the bits of the port 6 pull-up
setting register.
Address bit7
0062
-
H
-
R/W
: Readable/Writable
: Initial value
104
Figure 4.6-2 Pull-up Resistor Settings (PUL6)
bit6 bit5 bit4 bit3
- - -
-
- - - -
0
1
Initial value
bit2 bit1 bit0
------00
- PUL61 PUL60
-
R/W R/W
PUL60
PUL61
P61 pull-up OFF P60 pull-up OFF
P61 pull-up ON P60 pull-up ON
B