Fujitsu F2MC-8L F202RA Hardware Manual page 15

Main changes in this edition
Page
-
-
6 1.3 Differences between
Models
12 1.7 Pin Functions
19 2.1 Precautions on
Handling Devices
24 3.1.1 Specific-purpose
Areas
44 3.5 Reset
56 3.6.3 System Clock
Control Register (SYCC)
57
130 6.3 Watchdog Control
Register (WDTC)
186 8.6 Explanation of
Operations of Interval
Timer Functions
264 12.3 Pins of A/D
Converter
308 13.6.2 Reception
Operations (Operating
Mode 0, 1, or 3)
Changes (For details, refer to main body.)
The followings product name is changed.
(MB89202 → MB89202/F202RA)
The followings term is changed.
(source oscillation → oscillation frequency)
"Notes:" is changed.
(The followings sentence is deleted.
•
" At turning on the power, when the device is used without inputting the external
reset, select "reset output supported" and "power-on reset supported" by mask
option.")
The followings package is changed in Table 1.3-1.
(FPT-34P-M03 → FPT-32P-M03)
RST pin in Table 1.7-1 is changed.
"● External pull-up for the External Reset Pin (RST) of MB89F202/F202RA" is
changed.
The summary is changed.
"■ General-purpose Register Area (address: 0100
"■ Vector Table Area (Address: FFC0
"● Power-on reset" is changed.
"Note:" is deleted.
Figure 3.6-5 is changed.
Table 3.6-1 is changed.
Figure 6.3-1 is changed.
"● 8-bit mode"is changed.
(The followings sentence is deleted.
"The initial value of the square wave output is "L" level. The square wave output is
initialized by writing "0" to the TSTR bit of the timer control register (TCR).")
"■ Block Diagram of the Pins Related to the A/D Converter" is changed.
("Note:" is deleted.)
"■ Reception Operations (Operating Mode 0, 1, or 3)" is changed.
("Note:" is changed.)
xi
to 01FF )" is changed.
H H
to FFFF )" is changed.
H H