Memory Operation; Entering Memory Channels - Icom IC-T10 Basic Manual

5

MEMORY OPERATION

■ Entering Memory channels

The transceiver has a total of 200 Memory channels to
save often-used frequencies.
In the Memory mode, you can quickly select the saved
memories. This section describes the basic channel
content entry.
Example: Entering 145.800 MHz into Channel 11
1. Repeatedly push [V/M/C] to select the VFO mode.
2. Repeatedly push [BAND] to select the VHF band.
Set the frequency to 145.800 MHz.
3.
4. Push [S.MW] until two short beeps sounds.
• " " and the channel number blinks.
L Holding down even after two short beeps are sound
writes the set frequency to the currently selected
channel.
5. Roate [DIAL] to select Channel 11.
6. Push [S.MW] until two short beeps sounds to enter
145.800 MHz to Channel 11.
• The transceiver returns to the VFO mode.
15