Qlogic 12000 Series Reference Manual page 78

Switch Command Line Interface
Groups and Commands
Sample Output:
-> smShowSMParms
SM priority is set to 4
SM LMC is set to 0
SM sweep rate is set to 300
SM max retries on receive set to 3
SM max receive wait interval set to 250 millisecs
switchLifetime set to 15
HoqLife set to 9
VL Stall set to 5
packetLifetime constant is set to 18
Dynamic PLT ON using values: 1 hop=16, 2 hops=17, 3 hops=17, 4 hops=18,
5 hops=18, 6 hops=18, 7 hops=18, 8+hops=19
SM DBSync interval set to 900
SM topology errors threshold set to 0, max retry to 3
NOTES: Use this command to display a sampling of subnet manager parameters.
smPKeys
Configure a partition key (PKey) in the PKey table.
Syntax:
smPKeys
Options:
None.
Sample Output:
-> smPKeys
NOTES: PKeys are used for partitioning the subnet. Only configure PKeys if the
host driver supports this. Invalid configuration of the PKey may render the fabric
inoperable. The subnet manager must be running to display PKeys.
smInfoKey
Set the subnet manager key (SMInfo) value.
Syntax:
smInfoKey
Options:
None.
1-70 D000103-000 E