Qlogic 12000 Series Reference Manual page 121

NOTE:
ismShowPStatThresh
Displays the port statistic thresholds.
Syntax:
ismShowPStatThresh
Options:
None.
Sample Output:
-> ismShowPStatThresh
Field
-----
1 portXmitData:
2 portRecvData:
3 portXmitPkts:
4 portRecvPkts:
5 portXmitWait:
6 portSymbolErr:
7 portLinkErrRecv:
8 portLinkDowned:
9 portRecvErr:
10 portRecvRemPhysErr:
12 portXmitDiscard:
13 portPKeyViolIn:
14 portPKeyViolOut:
15 portRawViolIn:
16 portRawViolOut:
17 portLocalLinkInteg:
18 portExcBufferOverrun:
19 portRelayedVL15Dropped:
20 portLocalVL15Dropped:
21 portNonSMPDropped:
NOTE:
D000103-000 E
This command sets the supported link speed on each of the internal
switch-to-switch ports. This command does not cause the associated
ports to change the active or enabled speed of the port. The active
and enabled speed is changed the next time the port transitions down
and back up. Calling this function without a parameter displays the
current values of the port. Calling this function with the [-bounce]
option disruptively brings active links down and back up so the links
use the new setting immediately. Otherwise the new setting is used
the next time links retrain.
Threshold Time Unit
--------- ---------
0 (Percent of Max)
0 (Percent of Max)
0 (Percent of Max)
0 (Percent of Max)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
0 (1 Second)
The following are the available port statics thresholds:
1 portXmitData: 32-bit data words transmitted
2 portRecvData: 32-bit data words received
Switch Command Line Interface
Groups and Commands
1-113