Qlogic 12000 Series Reference Manual page 101

Sample Output:
-> logConfigure
Type Q or X to exit.
Please enter the number corresponding to what you want to configure.
index : name : description
--------------------------
1 : Device : Logging device. (IE. Ram, syslog, etc)
2 : Preset : General log filter.
Select: 1
Configurable devices
index : name : |D|F|E|A|W|P|C|I|P|N|1|2|3|4|5|
----------------------------------------------------
1 : Ram : |X|X|X|X|X| | | | |X| | | | | |
3 : Console : |X|X|X|X|X| | | | |X| | | | | |
5 : Syslog : |X|X|X|X|X| | | | |X| | | | | |
Type Q or X to exit
Enter the device index you wish to configure: 1
Level: Dump [1]
Level: Fatal [1]
Level: Error [1]
Level: Alarm [1]
Level: Warning [1]
Level: Partial [0]
Level: Config [0]
Level: Info [0]
Level: Periodic [0]
Level: Notice [1]
Level: Debug1 [0]
Level: Debug2 [0]
Level: Debug3 [0]
Level: Debug4 [0]
Level: Debug5 [0]
Log device configuration changed
...
NOTES: This is an interactive command to configure log settings. This involves
setting the log levels that are active.
Definitions:
D000103-000 E
Preset: Enable or disable each log level that may be generated on the
system. The log presets act as a general filter. For example, if the Info
logging level is disabled in the presets, no Info messages will be
shown on any output device, regardless of Info log setting for a device.
Device: Enable a device to display or process log messages of each
level. The level must also be active in Preset for log messages to be
processed for a device.
Syslog: Configure the syslog host ip address and port.
Switch Command Line Interface
Groups and Commands
1-93