Qlogic 12000 Series Reference Manual page 114

Switch Command Line Interface
Groups and Commands
Options:
enable
Enable the auto-clear feature.
disable
Disable the auto-clear feature.
warn
Generate warning log messages instead of the default information messages.
log_first
Log first clear (otherwise the first clear is not logged).
Sample Output:
-> ismAutoClearConf enable
Auto clear is enabled
NOTE:
ismPortSet12x
Allows the user to view, set and unset port link width for specific port(s).
Syntax:
ismPortSet12x portName [enable8xBit] [-bounce]
Options:
portName
A valid 6 or 7 character port name (e.g., S1AL01a or L01P01).
enable8xBit
2=enable(8X only) 1=enable(AUTO 1X/4X/8X), 0=disable.
-bounce
Brings the active links down and back up if a new value is set.
Sample Output:
-> ismPortSet12x S1AL01a
S1AL01a 12x mode is DISABLED
NOTES: This command is included for backwards compatibility. The
ismPortSetWidth command is preferred. This command ONLY works on platforms
1-106
This feature will log every time a counter has reached its maximum
capacity. This may be useful for diagnostics purposes, specifically
for bad cables. This feature is only available on certain switch
hardware platforms.
D000103-000 E