Qlogic 12000 Series Reference Manual page 50

Switch Command Line Interface
Groups and Commands
NOTES: This routine spawns a process to send ping packets to the specified IPv6
address. If packetCount is given, the process exits after that number of packets are
sent. If packetCount is omitted, a default the number of packets defaults to 5.
showChassisIpAddr
Displays the chassis IP address.
Syntax:
showChassisIpAddr
Options:
None.
Sample Output:
-> showChassisIpAddr
Chassis IP Address: 172.26.0.221 Net mask: 255.255.240.0
setChassisIpAddr
Change the OOB LAN IP address and network mask.
Syntax:
setChassisIpAddr -h ipaddress -m netMask
Options:
-h ipaddress
The new IP address in dotted notation format 'xxx.xxx.xxx.xxx'.
-m netMask
The network mask. (may be in dotted notation or hexidecimal format)
Sample Output:
-> setChassisIpAddr -h 172.26.0.221 -m 255.255.240.0
NOTES: Changing the chassis IP address will drop the connection to the CLI if not
using the console port and may cause the device to become unreachable.
setChassisIpv6Addr
Changes the chassis IPv6 address.
Syntax:
setChassisIpv6Addr [<ipv6Address> /<maskLen>]
1-42 D000103-000 E