Qlogic 12000 Series Reference Manual page 131

NOTE:
timeDSTConf
Configure and display the Daylight Saving Time settings.
Syntax:
timeDSTConf [sw sd sm ew ed em]
Options:
sw
Start which, valid values: 1 = 1st, 2 = 2nd, 3 = 3rd, 4 = 4th, 5 = 5th
sd
Start day, valid values: 1 = Sunday, 2 = Monday, 3 = Tuesday, 4 = Wednesday, 5 =
Thursday, 6 = Friday, 7 = Saturday
sm
Start month, valid values: 3 = March, 4 = April, 5 = May, 6 = June, 7 = July, 8 = August, 9
= September, 10 = October, 11 = November
ew
End which, valid values: 1 = 1st, 2 = 2nd, 3 = 3rd, 4 = 4th, 5 = 5th
ed
End day, valid values: 1 = Sunday, 2 = Monday, 3 = Tuesday, 4 = Wednesday, 5 =
Thursday, 6 = Friday, 7 = Saturday
em
End month, valid values: 3 = March, 4 = April, 5 = May, 6 = June, 7 = July, 8 = August, 9
= September, 10 = October, 11 = November
Sample Output:
-> timeDSTConf 2 1 3 1 1 11
Timezone offset successfully configured
Current DST = Start: 2'nd Sunday of March End: 1'st Sunday of November
NOTE:
D000103-000 E
The offset parameter specifies a time zone the system should use
when setting the time. In the U.S. the following time zones are in
effect: Eastern Standard Time = GMT -5; Central Standard Time =
GMT -6; Mountain Standard Time = GMT -7; Pacific Standard Time
= GMT -8. GMT = GreenwichMean Time..
Example: To set the daylight savings time to start on the 1st Sunday
of April and end on the 4th Sunday of October the command would
be: 'timeDSTConf 1 1 4 4 1 10'.
Switch Command Line Interface
Groups and Commands
1-123