Qlogic 12000 Series Reference Manual page 36

Switch Command Line Interface
Groups and Commands
This command can also be used to enable or disable various access methods. Use
'-<proto> 0' to disable a protocol, and '-<proto> 1' to enable. Multiple operations
may be specified in a single command.
A reboot is not required for this command. Depending on the specific method, it
may take 5-10 seconds for the changes. Note that existing connections (for example
a telnet session) will not be affected by disabling the underlying access method.
Any access method supported by the device (but not listed here) cannot be
configured and is always enabled.
genPost
Displays General POST results and runs tests
Syntax:
genPost
Options:
None.
Sample Output:
MasterMM202-> genpost
ID Gen POST Name
---------------------------------------------------------------------------
* POST TEST CPU
* POST TEST MEM DRAM
* POST TEST BOOTROM IMG CHKSUM
* POST TEST RUN-TIME IMG CHKSUM
* POST TEST JMP RAM
6 POST TEST I2C PROBE
7 POST TEST FAN TRAYS
8 POST TEST PWR SUPPLIES
9 POST TEST REAL-TIME CLOCK
10 POST TEST PROTO
NOTES: Displays General POST results and runs tests.
1-28
Result ENA DEM PWR Result-Ext
NO-RUN Y N Y
NO-RUN Y N Y
NO-RUN Y N Y
NO-RUN Y N Y
NO-RUN Y N Y
NO-RUN Y Y N
NO-RUN Y Y N
NO-RUN Y Y N
NO-RUN Y Y N
NO-RUN Y Y N
D000103-000 E