Qlogic 12000 Series Reference Manual page 29

loginMode
Allows the user to change the user interface authentication requirements.
Syntax:
loginMode [mode]
Options:
[mode]
Determines how users are able to login.
Sample Output:
-> loginMode 1
Mode successfully changed to: 1 = Password is not required
NOTES: This command displays or changes how users are authenticated when
connecting to the GUI or CLI. With no parameters, the current login mode is
displayed. The login mode can be changed by specifying a single integer parameter
indicating which of the following modes should become active:
0 - Username and password required
1 - Password is not required
2 - Username / password are not required
3 - LDAP Authentication
When usernames are disabled, all users will be logged on as the administrative
user. There is no way to change this behavior.
setldapSvrIpAddr
Modify the LDAP Server IP Address.
Syntax:
setldapSvrIpAddr [ipaddress]
Options:
[ipaddress]
The IP address of the ldap server you wish to set to authenticate in the format
"192.168.0.1"
Sample Output:
-> setldapSvrIpAddr 192.168.0.29
D000103-000 E
Switch Command Line Interface
Groups and Commands
1-21