Qlogic 12000 Series Reference Manual page 111

Optional Statistics
Note: The user is prompted to continue the output after each group of 24
ports are displayed. This command is best displayed with a terminal width of
at least 120 columns.
ismLinearFwdb
Displays the entries in the linear forwarding table. LIDs and a cooresponding port are shown. A packet
addressed to a LID will be forwared to the cooresonding port listed in the displayed table.
Syntax:
ismLinearFwdb [switch]
D000103-000 E
Symbol, Errors - Number of symbol errors received on the port.
Active, Speed - The active link speed of the port.
Active, Width - The active link width of the port.
Active, Potential - The port utilization based on the maximum
supported link speed and maximum supported link width.
PhysState - The physical state of the port.
PortState - The state of the link on this port.
LinkWidth - The currently active link width on this port.
LinkSpeed - The currently active link speed on this port.
SymblErrors - The number of 8B10B encoding or disparity violations.
ErrRecovery - The number of link error recovery proccess successes.
LinkDowned - The number of link error recovery process failures.
RcvErrors - Number of errors received on the port.
RmtPhysErr - Number of remote physical errors received on the port.
TxDiscards - Number of port transmit discards.
InPKeyViol - Number of times PKey inbound invalid.
OutPKeyViol - Number of times PKey outbound invalid.
InRawViol - Number of times raw inbound packet discarded.
OutRawViol - Number of times raw outbound packet was discarded.
LLIntegrity - Number of local link integrity errors.
ExcesBufOvr - Number of excessive buffer overrun errors.
Switch Command Line Interface
Groups and Commands
1-103