Qlogic 12000 Series Reference Manual page 30

Switch Command Line Interface
Groups and Commands
NOTES: This sets the LDAP server ip address. The LDAP server will be contacted
for remote authentication.
setldapSvrPort
Modify the LDAP Server Port.
Syntax:
setldapSvrPort [port]
Options:
[port]
The port of the LDAP server to be authenticated.
Sample Output:
-> setldapSvrPort 389
NOTES: Sets the LDAP server port. The LDAP server will be contacted for remote
authentication.
idleTimeoutGet
Retrieves the UI idle timeout value.
Syntax:
idleTimeoutGet [--all] [--cli] [--gui]
Options:
--all
Display all timeouts. This is the default if no options are specified.
--cli
Display the timeout for CLI sessions.
--gui
Display the timeout for GUI sessions.
Sample Output:
-> idleTimeoutGet
Timeout is 600 seconds.
NOTES: Displays the system idle timeouts for the GUI and CLI interfaces. If set to
zero, the timeout is disabled.
1-22 D000103-000 E