Member - Dell Networking 7048 Reference Manual

! Prefer the RJ45 port and leave the SFP port powered
on
console(config-if-Te1/0/24)#media-type auto-select
rj45

member

Use the member command in Stack Global Configuration mode to pre-
configure a switch stack member. Execute this command on the Management
Switch. To remove a stack-member configuration from the stack, use the no
form of the command.
The no form of the command may not be used if the member is present in the stack.
Syntax
unit switchindex
member
unit
no member
unit — The switch identifier of the switch to be added or removed from
•
the stack. (Range: 1–12)
switchindex — The index into the database of the supported switch types,
•
indicating the type of the switch being preconfigured. The switch index is
a 32-bit integer obtained from the
Default configuration
This command has no defaults.
Command Mode
Stack Global Configuration
User Guidelines
The switch index (SID) can be obtained by executing the
switchtype command in User Exec mode. When removing a unit from a
stack, use the no member command to remove the stack member
configuration after physically removing the unit.
1656
System Management Commands
show supported switchtype command.
show supported