Snmp-Server Community-Group - Dell Networking 7048 Reference Manual

The community name may include any printable characters except a double
quote or question mark. Enclose the string in double quotes to include spaces
within the name. The surrounding quotes are not used as part of the name.
The CLI does not filter illegal characters and may accept entries up to the
first illegal character or reject the entry entirely.
Example
The following example configures community access string public to permit
administrative access to SNMP at an administrative station with IP address
192.168.1.20.
console(config)# snmp-server community public su ipaddress 192.168.1.20

snmp-server community-group

Use the snmp-server community-group command in Global Configuration
mode to map the internal security name for SNMP v1 and SNMP v2 security
models to the group name. To remove the specified community string, use
the no form of this command.
Syntax
snmp-server community-group
address
]
• community-string — Community string that acts like a password and
permits access to the SNMP protocol. (Range: 1-20 characters)
group-name — Name of a previously defined group. The group defines the
•
objects available to the community. (Range: 1-30 characters)
• ip-address — Management station IP address. Default is all IP addresses.
Default Configuration
No community group is defined.
Command Mode
Global Configuration mode
1588
SNMP Commands
community string group-name
-
ip-
[ipaddress