Configuring And Enabling Call-Home Features; Configuring And Enabling Ethernet Events; Configuring, Enabling, And Testing Call-Home Event Notification - HP 316095-B21 Installation Manual

A check mark is displayed in the check box to indicate e-mail notification for the Edge Switch is
enabled, and the menu closes.
NOTE:
individually.

Configuring and enabling call-home features

There are two call-home features available, and only one is installed when the HAFM application is
installed on the HAFM appliance. To learn more about configuring call-home features, see the HP
StorageWorks HA-Fabric Manager Appliance installation guide.

Configuring and enabling Ethernet events

Perform this procedure to configure and enable Ethernet events. An Ethernet event is recorded (after
a user-specified time interval) when the Edge Switch-to-HAFM appliance communication link drops.
1. Minimize the Hardware view and return to the HAFM application.
2. At the HAFM or HAFM Basic main window, select the Monitor > Ethernet Event.
The Configure Ethernet Events dialog box is displayed
Figure 30 Configure Ethernet Events dialog box
3. Select the Enable Ethernet Events check box.
A check mark is displayed in the check box to indicate Ethernet events are enabled.
4. Enter a value from 10 through 120 minutes in the Ethernet Timeout box.
5. Click OK to close the dialog box.

Configuring, enabling, and testing call-home event notification

Telephone numbers and other information for the call-home feature are configured through the
Windows 2000 dial-up networking application. See
on page 62 for configuration information. To configure, enable, and test call-home event
notification:
1. Minimize the Hardware view and return to the HAFM application.
2. At the HAFM or HAFM Basic main window, select the Event Notification and Call Home options
from the Monitor menu.
62 Using HAFM to configure the Edge Switch
Using HAFM, enable or disable e-mail event notification for each Edge Switch
(Figure 30).
"Configuring and enabling call-home features"