Installing The Fixing Cleaning Belt - Canon NP6251 Service Manual

Hide thumbs Also See for NP6251:

Table of Contents

CHAPTER 6 FIXING SYSTEM

4. Installing the Fixing Cleaning Belt

Install the fixing cleaning belt by reversing the steps used to remove it.

1) Wind the cleaning belt around the cleaning belt take-up roller

When installing it to the front, be sure that the arm guide plate

of the take-up roller.

At this time, check to make sure that the area coming into contact with the roller is

impregnated with oil.

Check to make sure that the fixing cleaning belt is not wound askew or it is not slack

or wrinkled.

In addition, make sure that the direction of winding and the orientation are as shown

in Figure 6-203.

2) After installing the fixing cleaning belt, move the one-way lever

the arrow (Figure 6-208); then, turn it until all the slack has been removed from the

fixing cleaning belt.

Be sure to reset the counter (*6*; 'WEB') to '0' after replacing the fixing cleaning

Figure 6-207

Figure 6-208

CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)

twice to three times.

is on the outside

in the direction of

Table of Contents