4. Removing the Deck Lifter Motor (M102)
1) Open the compartment of the deck; remove all copy paper, if any.
2) Turn on the copier; if the lifter of the deck is up, push the sensor lever
supply position inside the compartment with a finger. Stop the lifter
from the base of the compartment, and insert a hex wrench
lifter drive shaft
from turning.
Figure 8-403
3) Remove the compartment from the deck. (See p. 8-30.)
4) Disconnect the two connectors
deck lifter motor unit
COPYRIGHT © 1997 CANON INC.
, and fix the lifter drive shaft
, and remove the five screws
.
Figure 8-405
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 8 PAPER DECK-A1
into the hole of the
temporarily in place to prevent it
Figure 8-404
; then, remove the
of the paper
about 7 cm
8-37