Canon NP6251 Service Manual page 154

Hide thumbs Also See for NP6251:
Table of Contents

Advertisement

CHAPTER 4 IMAGE FORMATION SYSTEM
3) Remove the two mounting screws
support plate
4) While pushing the electrode block at the rear toward the rear, remove the scanning
lamp
.
Caution:
1. Do not work if the surface of the scanning lamp is hot.
2. Do not leave fingerprints on the surface of the scanning lamp.
3. If the surface of the scanning lamp is soiled, dry wipe it.
4. Do not leave fingerprints on the reflecting shade.
5. Do not deform the reflecting shade.
6. To install the lens hood, fit the boss of the lens hood in the cut-off of the rail at
the front, and then engage the hook at the rear while turning the lens hood
slightly clockwise.
4-40
COPYRIGHT © 1997 CANON INC.
.
Figure 4-301
Figure 4-302
, and remove the reflecting shade
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
and the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Np6350

Table of Contents