Canon NP6251 Service Manual page 510

13) Fix the top cover with two screws. (At this time, make sure that the cable of the power
supply unit is fixed in place inside the Copy Data Controller-A1 and is not trapped by
the top cover.)
14) If you are connecting the Control Card Printer A-1, connect it to the connector (J4)
of Copy Data Controller-A1. (As necessary, use a relay cable.)
If off-line control is planned, connect it to the RS232C I/F connector of Copy Data
Controller-A1.
15) End the installation after making sure that no cable is outside of the Copy Data
Controller-A1.
Put the petty-pull at the lower right of the copier's rear.
16) Hook the cable connected to the Copy Data Controller-A1 on the petty-pull.
17) Make sure that no cable is trapped by the casters of the copier or the sorter.
COPYRIGHT © 1997 CANON INC.
Fig. 9-523
Copy Data
Controller-A1
Fig. 9-524
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 9 INSTALLATION
RS232C I/F
connector
J4
Petty-pull
9-55