Canon NP6251 Service Manual page 505

CHAPTER 9 INSTALLATION
Using an Existing ID
a) Set the DIP switch (SW1) on the Copy Data Controller-A1 as indicated:
b) Press the switch (SW4) on the Copy Data Controller-A1.
LED5 turns on for a brief moment when the data has been drawn successfully.
c) LED5 flashes if the attempt to draw the data fails. Press the switch (SW4) once
again, and check that LED5 turns on.
The copier cannot deliver paper while data is being drawn.
d) Set the DIP switch (SW1) on the Copy Data Controller-A1 as follows. (LED5 should
go out.)
9-50
COPYRIGHT © 1997 CANON INC.
Bit
SW1 1, 2
3
Table 9-503
Bit
SW1
1, 2, 3
Table 9-504
LED1 LED2 LED3
LED1 LED2 LED3
SW2
SW3
LED4 LED5 LED6
LED5
6 1 6 1
SW1 ON SW5 ON
SW1-3 SW1-2 SW1-1
Fig. 9-518
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Position
ON
OFF
Position
OFF
JA1
JB2
JA2
JB1
SW4
SW4