Installing The Copy Tray; Replacing The Delivery Gear - Canon NP6251 Service Manual

CHAPTER 9 INSTALLATION
E. Installing the Copy Tray

1. Replacing the Delivery Gear

If you are not installing a stapler sorter or a sorter to the machine (i.e., if you will be
using the copy tray), you must replace the delivery gear with the gear (black) for the copy
tray.
If you are installing a stapler sorter or a sorter, on the other hand, be sure to check
that the gear is positioned as shown in illustration 1 of the table, and skip the steps that
follow.
Step
1 Open the front door, and slide out
the fixing/feeding assembly; then,
remove the fixing knob, releasing
lever, and fixing feeding cover.
Remove the E-ring, and remove the
delivery gear (white) from the
machine.
2 Replace the gear with the delivery
gear (attached to the copy tray), and
install the E-ring.
Caution:
Be sure that the groove on the
female side of the new gear and
the male side of the torque limiter
are engaged.
9-16
COPYRIGHT © 1997 CANON INC.
Work
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
White gear
(for sorter)
Torque limiter
E-ring
Black gear
(for tray)
Torque limiter
E-ring