Installing The Ap Kit And The Charging Assemblies - Canon NP6251 Service Manual

Hide thumbs Also See for NP6251:
Table of Contents

Advertisement

CHAPTER 9 INSTALLATION
D. Installing the AP Kit and the Charging Assemblies
Step
1
Remove the screw from the
releasing lever of the fixing/feeding
assembly. While pushing the rear
(fixing/feeding assembly inside) of
the releasing lever locking shaft,
shift up the releasing lever to
remove the releasing lever. Remove
the screw, and remove the fixing
knob; then, remove the three
screws, and remove the
fixing/feeding assembly cover.
2
Remove the screw, and remove the
metal fixing; then, disconnect the
connector. Holding the front and the
rear
of
the
charging
assembly to the front, and then pull it
to the upper left to remove.
Using alcohol, clean the transfer/
separation charging assembly.
Install
the
charging assembly, connect the
connector.
Install the metal fixing.
Caution:
Be sure to keep the transfer/
separation charging assembly
in contact with the transfer
guide, and take care not to
damage the gut wire.
Further, be sure that the
charging assembly is fully dry.
9-10
COPYRIGHT © 1997 CANON INC.
Work
transfer/separation
assembly,
pull
transfer/separation
Fixing
knob
Screws
the
Metal
Screw
fixing
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
Releasing lever
locking shaft
(rear)
Fixing/feeding
Screw
assembly cover
Screw
Screw
Releasing
lever
w
q
Connector

Advertisement

Table of Contents
loading

This manual is also suitable for:

Np6350

Table of Contents