CHAPTER 5 PICK-UP/FEEDING SYSTEM
2. Removing the Lifter Cable
1) Remove the paper deck.
2) Remove the two mounting screws
on the side; then, remove the deck front cover
3) Remove the two mounting screws
guide plates
4) Mark the position of the latch assembly; then, remove the left and right mounting
screws
(7 in total), and remove the latch assembly
5) Remove the gear cover
5-72
COPYRIGHT © 1997 CANON INC.
.
Figure 5-821
from the front right.
Figure 5-822a (left)
above, and loosen the two mounting screws
.
inside the deck, and remove the front and rear
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
.