Installing The Fixing Cleaning Belt - Canon NP6260 Service Manual

4. Installing the Fixing Cleaning Belt

Install the fixing cleaning belt by
reversing the steps used to remove it.
1) Wind the cleaning belt around the
cleaning belt take-up roller
to three times. When installing it to
the front, be sure that the arm guide
plate is on the outside of the
take-up roller.
At this time, check to make sure that
the area coming into contact with the
roller is impregnated with oil.
Caution:
Check to make sure that the fixing
cleaning belt is not wound askew
or it is not slack or wrinkled.
In addition, make sure that the
direction of winding and the
orientation are as shown in Figure
6-203.
2) After installing the fixing cleaning
belt, move the one-way lever
the direction of the arrow (Figure 6-
208); then, turn it until all the slack
has been removed from the fixing
cleaning belt.
Caution:
Be sure to reset the counter (*6*;
'WEB') to '0' after replacing the
fixing cleaning belt.
COPYRIGHT © 1997 CANON INC.
twice
in
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 FIXING SYSTEM
Figure 6-207
Figure 6-208
6-21