Canon NP6251 Service Manual page 169

7) Cut the excess charging wire with a nipper.
8) Pick the end of the charging wire tensioning spring with tweezers, and hook it on the
charging electrode.
In the case of the transfer charging assembly, hook it on the pin at the front.
Caution:
After stringing the wire, check to make sure that
• It is not bent or twisted in the middle and its gold plating has not peeled.
• It is in the V-groove of the charging wire positioner.
9) Install the cushion at the front of the charging wire. (This does not apply to the
primary charging assembly.)
10) Install the shielding plates (left, right).
Caution:
For other charging assemblies, install the two lids.
COPYRIGHT © 1997 CANON INC.
Figure 4-327
(correct)
Grid side
(correct)
Figure 4-328 Primary Charging Wire
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
(wrong)
(wrong)
4-55